On August 17th, 2010 I was golfing alone when I teed up on the 8th hole at Wild Ridge golf course in Eau Claire, Wisconsin. It was early in the morning and the sun was shining in my eyes. I was using A NXT Tour ball and 7 iron. I hit a bad line drive…
Grant,
One shaft that I've seen work well with controlling spin, while maintaining a decent launch angle is the Graphite Design DI-6. I would recommend working first hand with a Club Fitter who will be able to see your launch and spin and how it…
I doubt Titleist will go back to that size of drivers, because the days of the small drivers have past. Everything now is around 460cc for head size. Too me the new ones are easier to hit than the old ones though.
There were 8 of us playing, in two separate groups, we teed off a little after 11am. I had hit the stick with my 2nd shot on #1 and sadly missed the 4ft putt for birdie. Then on #3, the GPS was reading 157 on our cart, but the cart behind us said 152…
Most likely to happen, considering the new make and model. Just purchased a used 910f 19* from a certifited PGA store on ebay for $82! Might consider driver now...
I was nicley surprized to find I was chosen to test a Titleist prototype ball, I was careful where i used it so I would'nt lose it. A par 3 plays 154 yards but today the pin was down in the front, playing 141 yards. This green slopes severely left to…
Hello Steve,There are no plans right now to send out another ball cube as it usually coincides with a NEW ball launch. If it does indeed come to fruition, Team Titleist will be the first to know.
Regards,Mitch DTeam Titleist CAnada
Playing a friendly round at the Preserve, where ever week there is a game going where a little money is involved. I started the round with a double bogey on one. Didn't really get too down about it because it was the first hole. Pared the second hole…
Worcester State University. It is a Division III school. I switched from Tech V3s to AP2s. I will pick up some new wedges pretty soon and do the rest in a couple of months.
Hi Alistair,
I'm afraid there are not options to change the finish of a putter - only to return a putter to its original finish.
Thanks